Motorola AP-5131 Installation Manual page 26

20 AP-5131 Access Point: Installation Guide
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the Power
Injector Data In connector.
b. Connect a RJ-45 Ethernet cable between the Power Injector Data & Power Out
connector and the AP-5131 LAN port.
c. Ensure the cable length from the Ethernet source (host) to the Power Injector and
AP-5131 does not exceed 100 meters (333 ft). The Power Injector has no On/Off power
switch. The Power Injector receives power as soon as AC power is applied. For more
information on using the Power Injector, see "
For standard power adapter (non Power Injector) and line cord installations:
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the AP-5131
LAN port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the AP-5131.
e. Attach the power supply line cord to a power supply.
CAUTION
16. Verify the behavior of the AP-5131 LED light pipe. For more information, see
"
LED Indicators
17. Place the ceiling tile back in its frame and verify it is secure.
18. The AP-5131 is ready to configure. For information on basic AP-5131 device configuration,
see "
Configuring "Basic" Device Settings
Do not actually connect to the power source until the cabling portion
of the installation is complete.
" on page 21.
Power Injector System
" on page 25.
" on page 8.