Santana PS-10 Service Manual page 537

7D-32 TRANSFER BOX
16
45) Fit conical bearings (22) of drive gear (23).
23
22
46) Fit drive gear bearing exterior rings to the transfer box ca-
47) Fit drive gear (23) and the rear cover fixed with screws (16)
48) Attach a meter to the gear and measure its longitudinal play.
49) Add to this measurement the corresponding thickness of
50) Look for a washer the same thickness as the play plus the
23
51) Fit one new "O" ring (13) in the assembly groove of the
13
sing and to the support cover to the rear of the gears.
NOTE:
Do not fit the assembly washer between the rear cover and
the exterior ring of the bearing at the moment.
the pre-tingten of the bearings.
Pre-tingten thickness:
0,025 ÷ 0,076 mm
pre-tingten thickness, place it in the ring in the rear cover
and carry out the final assembly.
intermediate gear shaft and another in the groove of the shaft
itself.
NOTE:
Apply a layer of grease to both "O" rings.