Santana PS-10 Service Manual page 342

UP.
CENT .
INF.
D
Piston rings installation
11) Using clamping tool (C), install piston rings to as indicated
C
Piston and connecting rod assembly installation on
cylinders
NOTE:
Install each assembly constituted by the piston, connecting
rod and connecting roo bearings, in the same cylinder
they were located before removal.
12) Lubricate generously pistons, piston rings and cylinders.
13) Using piston ring compressor (D), install piston and
in figure at the left.
connecting rod assembly into corresponding cylinder hose
noting the following remarks:
ENGINE REPAIR 6A-131