Santana PS-10 Service Manual page 319

6A-108 ENGINE REPAIR
7
G-1
G-2
G-3
Connecting rod foot bushies
2) Control that connecting rod bush foot is no loose in its
housing , that there are no symptoms of gripping, scratches
or excessive wear. Replace if necessary .
3) To replace bush use a pushing cylindrical hand tool as
required.
While installation, ensure alignment of lubrication hole. Once
bushing is installation, adjust properly insides to get the
specified diameter.
Internal diameter for rod foot connecting bush:
32,010 ÷ 32,020 mm
4) Check that play between connecting rod foot bush and bolt
of piston keeps to specified value.
Play between connecting foot bush and gudgeon pin
of piston: 0,014 ÷ 0,03 mm
Connecting installation rod on the verifying tool
verifying torsion and flexion
5) Install connecting rod to be checked (7) on tool(G) ref. 790978
as follows:
• Place connecting rod in mandril (G-2) and fíx it with screw
(G-3).
• Put mandril (G-2) over the two "V" of tool (G), lying
connecting rod in the blocking bar (G-1).
G-4
• Install piston pin (G-4) in connecting rod foot bush.
G