Filling The Sea With A Compressor Fill Adapter - Aqua Lung SEA MK User Manual

12 SEA USER'S MANUAL

Filling the SeA with a Compressor Fill Adapter

CAUtIoN:
compressed air filling station unless you have received
the necessary training and authorization to do so. If done
incorrectly, this procedure poses certain hazards which
may cause severe injury or death.
NOTE: Part Numbers 108382 & 108545 do not have an on/
off valve; therefore, the pressure indicator gauge and second
stage are always active when the cylinder is pressurized
CAUtIoN:
fill system gauge as indicator of fill pressure.
1. Inspect the fill adapter to ensure that the o-ring is present and seated
evenly inside its groove and the male fitting is clean and free of any dam-
age to its threads.
2. Fit the male fitting of the fill adapter into the high pressure fill port of
the first stage, and turn clockwise only by hand until lightly snug. DO
NOT apply a wrench or otherwise overtighten the fill adapter.
3. Loosen the yoke screw of the compressor fill yoke as needed so that
the yoke can be placed over the block of the fill adapter.
4. While supporting the SEA with one hand,
place the yoke of the compressor fill yoke over
the block of the fill adapter to align the inlet fit-
ting flush against the valve o-ring. Tighten the
fill yoke screw clockwise into the small dimple
on the backside of the fill adapter block only
until finger snug.
NOTE: The Compressor Fill Adapter (P/N 100656) is not
included with SEA and must be purchased separately.
Do not attempt to fill the SEA directly from a
the dial indicator is for reference only. Use