HP Apollo 9000 400dl Service Handbook page 67

Selecting the Primary Network
Perform the followingsteps to select the primary network for the system. If you
are selecting a primary network for a diskkss system, select the same primary
network used by the partner node.
1.
2.
3.
4.
Stop any user processes and log out.
Shut down to the MD prompt by typing the followingat the login:
prompt
login:
shut <RETURN>
T~ the followingat the MD prompt(>)
> pnet
x <
RETURN>
where x corresponds to one of the followingvalues:
e for 802.3 network
rtl for Apollo Token Ring network with network controller O
rl
for A 110 Token Ring network with network controller 1
Y tO for 80 5 network with network controller O
tl for 802,5 network with network controller 1
If the system uses two Apollo Token Ring or 802.5 network controller
boards, you must specifycontroller O(ro or tO)or controller 1 (rl or tl)
as the primary controller. The default is O.
T~ the pnet command to confirm the primary network
> pnet <RETURN>
You receive the followingsystem message:
APOLLO TOKEN RING : CONTROLLER = O
l%e
example display shows that the primary netwdc is set to controlle
Ofor the Apollo Token Ring network.
W@uration
3-35