Using The Hp-Ux Ce.utilities - HP Apollo 9000 400dl Service Handbook

Using the HP-UX ce.utilities
Perform the followingsteps to select and
run ce.utilities
on HP-UX systems.
1.
2
3.
4.
5.
6.
7.
5-14
If not already connected, cmnneeta tape drive to the system for the System
Support Tape.
Verify
the
system unit is in the HP-UX compatible mode.
Refer to Appendix C of
Setvicing the HP Apollo 9000 Series 400
Models
400dl,
400t, 425t, 400s, 425s, 433s
for detailed instructions.
From the Auto S tern Select Male, note the
tape drive with the System
r
Support Tape vat these operating systems:
SYSTEM_SF
sYsTEM_s3
If ou want to run the Series XXI System Functional Tats, select
SY~TEM_SF as the temporary operating system to Mot.
If you want to run the Series 300Computer Tests,selectSYSTEM_S3as the
temporary operating system to boot.
Refer to the
System Support Tqe User'sGuide
and the Seritx300
Ttit Tmls
MunuuJ
for detailed instructions.
To continue and run specific ce.utilities tests, boot the HP-UX operatin
R
s tern. The remaining steps of this procedure can only be performed W
r t e HP-UX operating system
running.
To list all tests on the tape,
T
the followingcommand, where
drive is
the
device file name of the tape rive:
Iifls Idevldnve <Return >
To find out what files are available for a certain test, type the following
command:
Iifcp -r Idevldn"ve:filenamel - I
cpio
-ictv <Return >
where
jilenamel
is one of these six ce.utility tests:
CRTADJ
FLOAT ECC
csao
SFT
WE
drive is
the device file name of the tape drive.
Note that the HP 98720Aand HP98730Atests are not supported on Series
400 system units.
Diagnostics