Max Re-Bar-Tier RB397 Operating And Maintenance Manual page 27

No. Normal Operation
Trigger ON → Wire
3. Sending of wire
sent out. is stopped half-
way.
4. Binding wire draws Curl is disor-
a circle. dered and steps
out of curl guide.
5. Wire is subject to No wire cutting
cutting. takes place.
6. Wire twisting takes Wire gets entan-
place. gled.
Binding power is
weak.
Twisting-off
takes place.
Works properly
Warning
Problem
Sound
Four short
beeps repeat-
ed
(Pipipipi,
pipipipi, ...)
Three short
beeps repeat-
ed
(Pipipi,
pipipi, ...)
No sound
emitted.
No sound
emitted.
No sound
emitted.
A short beep
and a long
beep, repeat-
edly.
(Pipipipipipi...)
No sound
emitted.
No sound
emitted.
Two short
beeps.
(Pipi)
Cause
Tie-Wire is not set in Check if the Tie-Wire has
the tool. been set in the tool.
Binding wire not of Confirm reel side face.
designated types
has been used.
Binding wire has Confirm reel winding
been entangled in-
side reel.
Wire, by hitting Rein- Check if wire hits Rein-
forcing bars, was re- forcing bars at binding.
pelled.
Cutter section is Confirm function of Cut-
blocked with foreign ter section.
substance.
Wire, by hitting Rein- Check if wire hits Rein-
forcing bars, was re- forcing bars at binding.
pelted.
Binding wire has Turn off power and take
been entangled out battery to confirm if
around Twist sec- binding wire has been
tion. entangled inside curl
guide.
Reinforcing bars is Confirm size of Reinforc-
not of designated ing bars to be bound.
size. (SEE PAGE 12)
Erroneous handling Confirm how to apply Ma-
such as improper ap- chine to Reinforcing bars.
plication of Machine.
Function of curl Check if curl guide is left
guide switch open at binding.
Reinforcing bars is Confirm size of Reinforc-
not of designated ing bars at binding.
size. (SEE PAGE 12)
Erroneous handling Confirm how to apply Ma-
such as improper ap- chine to Reinforcing bars.
plication of Machine.
Low power remains Confirm the battery is ful-
in the Battery pack. ly charged.
The tool is used at Check the temperature at
low temperature. the job site.
28
What to Check
Set the Tie-Wire.
Use MAX Tie-Wire
TW897A.
Remove fray on reel.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
Either wipe Cutter sec-
tion with dry cloth or blow
it with air.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
(SEE PAGE 23)
Turning off power, re-
move binding wire inside
curl guide.
Use appropriate diame-
ter scope.
Turning Torque dial in +
and inserting in vertical
direction, use as tilting at
45°. (SEE PAGE 22
AND 23)
Do not operate Machine
until binding is complet-
ed.
Use appropriate diame-
ter scope.
Turning Torque dial in –
(minus) and inserting in
vertical direction, use as
tilting at 45°. (SEE PAGE
22 AND 23)
Perform normal charge
after the tying speed
slows down considera-
bly.
Leave the tool and the
battery pack at normal
temperature in the room
for some time, and then
continue the operation.
Solution