Max Re-Bar-Tier RB397 Operating And Maintenance Manual page 17

Tie-Wire
2 Peel off the tape fixing Tie-Wire by about 2"
(5cm). Stretch out the tip of the wound Tie-
Wire.
BE SURE TO USE ONLY THE SPECIFIED TIE-
WIRE (MAX TW897A).
The use of binding wire that has not been speci-
fied may cause breakdown of this equipment.
Therefore, be sure only to use the specified MAX
TW897A. Do not use binding wire that has be-
come rusted, since the use of rusted wire will
cause equipment breakdown.
∗ TW897 cannot be used for RB397.
Reel stopper
3 Push the reel stopper to release the reel
holder.
4 Set the Tie-Wire in the tool by matching the
5 Insert the tip of the stretched out Tie-Wire
Reel holder
• Put the Wire around 4" (10cm) inside the
• The tip of the Tie-Wire should be straight-
18
Tie-Wire
side of the Tie-Wire as shown in the picture.
Then slide the Reel stopper so that the Reel
Holder can be pushed in the Reel. Then
push the Reel Holder and fix it by sliding the
Reel stopper.
Feeding gears
Pipe
into the Wire Guide. Then put it into the Pipe.
WARNING
Pipe.
ened out to allow it to pass through the wire
feeding mechanism.
When mounting the Tie-Wire, the wire may
become jammed inside the machine if the
wire tip is bent.
Reel Stopper
Reel
holder
Wire guide