WAGNER PROCOAT MAX Owner's Manual page 16

Cleanup
or
MINERAL
SPIRITS
You will need:
Start
• A water source that can be delivered
with a garden hose (latex materials only)
• Mineral spirits if using oil-based material
• Empty waste container
• A container with warm, soapy water
Follow these steps if you used latex materials anD if
you have a garden hose available.
STOP
If you do not have a garden hose available, follow the
Cleanup - Oil-Based materials instructions on page 18.
1
PRIME
1. Perform Pressure Relief Procedure
(page 7).
English
Cleaning notes - read before cleaning
• When using latex material, clean sprayer and components with warm, soapy water. For oil based
material use mineral spirits. Never use mineral spirits with latex materials
• NEVER use gasoline to clean sprayer
• Dispose of used cleaning solution properly
• Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage
• If you flush your sprayer with mineral spirits, repeat Cleanup instructions using warm, soapy water.
Follow these steps whenever cleaning with mineral spirits:
• If spraying or cleaning with oil-based materials, the spray gun must be grounded while preparing
the spray hose or cleaning.
• Ground the gun by holding it against the edge of a metal container while purging. Failure to do so
may lead to a static electric discharge which may cause a fire.
• Always flush spray gun at least one hose length from spray pump.
• If collecting flushed solvent in one gallon metal container, place it into an empty five gallon
container, then flush.
• Area must be free from vapors.
• Follow all cleanup instructions.
2
2. Remove the spray tip and 3. Place the suction tube and return tube
place into container filled
with warm, soapy water.
3
into an empty waste container.
16
4
4. Using a garden hose, rinse off the
suction tube, return tube and inlet filter.
Empty the waste container of all fluids.