Operation; Filling The Tank; Install The Tank; Fitting The Plug - Kärcher BR VS 400 Operating Instructions Manual

English

Install the tank

Place the tank on the cleaner

OPERATION

Fill the tank
Note:
Observe the dosing
recommendations of the cleaning
agent's manufacturer and mix the
cleaning agent solution thoroughly.
Take care when handling cleaning
agents!
Comply with the safety
*
recommendations of the cleaning
agent's manufacturer
Rinse splashes in eyes or on the
*
skin out or off with plenty of clean
water
Call a doctor immediately
*
Wash contaminated clothing with
*
water
Open the cap
Fill the tank with the required amount
of fresh water
Note:
The maximum water temperature
must be 50°C.
Place the tank onto the cleaner
–
Check that the tank is positioned
–
correctly
BR VS 400 *USA
Fill the tank with the required amount
of cleaning agent
Close the catch
–
Use a cloth to wipe away excess
–
liquid that pours out
Mix the cleaning agent well
–

Fitting the plug

Connect the plug to the power cable
Hang the power cable in the strain-
–
reliever
Plug the cable into the power
–
socket

Set the splash guard

Undo the fastening screw
–
6
Set the splash guard according to
–
each application.
Tighten fastening screw.
–
Note:
Adjust the splash guard parallel to the
floor

Turning the pushing handle

Press the pushing handle
–
downwards and turn to the LEFT or
RIGHT
Release strain on the pushing
–
handle and turn, it locks in several
positions