Raymarine Evolution EV-2 Installation Instructions Manual page 27

D12768-1
1. Affix the small sealing ring to the groove located on the
bottom of the mounting bracket.
2. Affix the tray to the mounting bracket and secure using the
supplied screws in the 3 positions indicated in the above
illustration.
3. Affix the large sealing ring into the groove on the upper side
of the mounting tray.
4. Affix the bracket to the mounting surface using the supplied
mounting template. Secure the bracket using the supplied
screws in the 3 positions indicated in the illustration above.
5. Pull the SeaTalk ng and DeviceNet cables through the
mounting bracket hole and the mounting tray. Insert the
plugs into the EV-2 unit.
6. Secure the EV-2 unit to the mounting tray by positioning
and inserting carefully in alignment with the grooves in the
mounting tray.
Important: The EV-2 unit must be mounted with the arrow
on the top of the unit in parallel alignment with the vessel's
longitudinal axis.
7. Place the EV-2 mounting trim over the EV-2 unit and push
the trim together with the mounting tray until the 2 items click
into position.
Installation
Dismantling the EV-1 and EV-2 enclosure
Once the mounting trim and mounting bracket are clicked into
position with the EV-1 or EV-2 unit inside, you must release
the clips if you need to subsequently remove the unit from the
enclosure.
1
1. Push the end point of a pencil or similar tool into one of the
clips located around the outside edge of the EV-1 or EV-2
enclosure.
The mounting trim will be released from the mounting bracket.
2. If necessary, repeat for all 4 clips located around the EV-1
or EV-2 enclosure, until the mounting trim is completely
released.
Note: To avoid potential damage or permanent markings
to the clips, only use a non-abrasive and non-permanent
marking tool to perform the above procedure.
D12775-1
27