Wall Mounting - Panasonic KX-UT113 Operating Instructions Manual

Wall Mounting

Before Mounting on a Wall
To mount the unit, it is necessary to remove the stand. For details, see "Removing the Stand (Page 65)".
Mounting the Unit
WARNING
•
Do not mount the unit in a manner other than that described in this section.
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit. If not, it is
necessary for the wall to be reinforced. For information about the weight of the unit, see "Specifications
(Page 81)".
•
Only use the optional wall mount kit with the unit. The wall mount kit includes the necessary screws,
washers, and wall mounting adaptor.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
When this unit is no longer in use, make sure to detach it from the wall.
CAUTION
•
Make sure the cables are securely fastened to the wall.
Notice
•
If you place the display face down when you attach the wall mounting adaptor, be sure to place a soft
cloth under the display before attaching the adaptor. Failure to do so may result in damage to the
display.
1.
Insert the 3 tabs (for KX-UT113/KX-UT123) or 5 tabs (for KX-UT133/KX-UT136/KX-UT248) of the wall
mounting adaptor into the designated openings in the base, and then slide the wall mounting adaptor in
the direction of the arrow until it clicks.
For KX-UT113/KX-UT123:
Document Version 2013-03
Installation and Setup
Operating Instructions 71