Oki Microline 520 Service Handbook page 109

Continuous Feed Paper
Set the change lever to either the REAR FEED or BOTTOM FEED position.
NOTE:
When the change lever is in the REAR FEED or BOTTOM FEED position, the cut sheet
detection lever does NOT contact the cut sheet detection switch (BASW), which is
located on the main control board.
Place continuous feed paper in the appropriate tractor.
Press the FF/LOAD switch.
The line feed motor will feed the paper until the leading edge of the paper reaches the top
of form position.
Microline 520/521 Service Handbook
P/N 59257803
2 - 37
2-2-08b.tif
Principles of Operation