Oki Microline 520 Service Handbook page 110

2.2.09 Paper Park
If continuous feed paper is installed and printing on cut sheet paper is desired, it is not necessary
to unload the continuous feed paper. The Paper Park feature provides a means of retracting the
continuous feed paper from the paper path, while (at the same time) cut sheet paper is fed.
Paper Park Operation
Place the change lever in the REAR FEED or BOTTOM FEED position.
Press the PARK switch on the operation panel.
A reverse line feed operation retracts the paper until paper-end occurs or 19 inches of
paper have been retracted.
NOTE:
Retracting 19 inches of paper without detecting a paper-end condition causes the line
feed operation to stop. The line feed operation stops because the printer assumes a jam
has occurred.
The operator can press the SEL switch to reset the ALARM LED and press the PARK
switch to continue the park operation.
This operation may be useful when length of the paper to be parked is greater than
19 inches.
Principles of Operation 2 - 38 Microline 520/521 Service Handbook
2-2-09.tif
P/N 59257803