Oki Microline 520 Service Handbook page 184

Printing the Menu
Printing the Menu provides a reference of current menu settings.
This will help you move through the menu.
Okidata STRONGLY RECOMMENDS printing the Menu before resetting the Menu to factory
defaults.
Once the Menu is reset, all customized settings are LOST.
To print the Menu, follow this procedure.
1. Verify that continuous feed paper is installed.
2. Verify that the ribbon is correctly installed.
3. Verify that the width of the installed paper matches the paper width menu setting.
CAUTION:
If the Menu is set for wide paper, and narrow paper is used, the printhead will print on
the platen. This could damage / destroy the printhead, platen, and ribbon.
4. Press and hold the SHIFT switch while pressing the SEL switch.
5. The MENU lamp will light. If the printer was selected, the SELECT lamp will light.
When in Menu Mode, the functions printed below the operator panel switches are active.
6. Press the PRINT switch.
7. The Menu will print.
8. Press EXIT to exit Menu Mode.
For more information regarding the menu, please refer to the Printer Handbook.
Maintenance 3 - 72 Microline 520/521 Service Handbook
P/N 59257803