Lsisas9207-4I4E Hba Characteristics - LSI PCI Express to 6Gb/s Serial Attached SCSI (SAS) User Manual

PCI Express to 6Gb/s Serial Attach SCSI (SAS) Host Bus Adapters User Guide
June 2012
3.1.12.4 Physical Characteristics
The LSISAS9207-8i HBA is a 6.6-in. × 2.7-in., low-profile board. The component height on the top and bottom of the
LSISAS9207-8i HBA is in accordance with the PCIe specification. The following figure shows the board layout.
Figure 13 LSISAS9207-8i Board Layout
EC1: PCIe x8-lane board edge connector

J5, J6: SFF-8087 mini-SAS, internal connectors

CR1: Heartbeat LED

J3: UART connection

3.1.13

LSISAS9207-4i4e HBA Characteristics

3.1.13.1 Memory
The LSISAS9207-4i4e HBA provides one 4-M × 16-bit Flash ROM for storing the firmware and BIOS.
3.1.13.2 LED
The LSISAS9207-4i4e HBA heartbeat LED, CR1, blinks green to indicate that the HBA is capable of general activity.
3.1.13.3 Connectors
This section describes the different connectors on the LSISAS9207-4i4e HBA.
PCIe Connector (EC1). The LSISAS9207-4i4e HBA supports a x8 interface. The PCIe host interface connection is
through the edge connector (EC1) which provides connections on both the top (EC1B) and bottom (EC1A) of the
board. The signal definitions and pin numbers conform to the PCIe specification.
SAS Connector (J6 and J7). The LSISAS9207-4i4e HBA supports SAS connections through connector J6, which is an
SFF-8088 mini-SAS, external, right-angle connector, and connector J7 which is an SFF-8087 internal mini-SAS
connector. The HBA supports SAS sideband signal assignments.
LSI Corporation
- 27 -
Host Bus Adapter Characteristics
Characteristics of the LSI 6Gb/s HBAs
See Figure 14 for connector locations.