Advertisement
Avalon Ashpan Installation Instructions
2
Place the included screen (or other screen) over the hole to act as a rodent barrier. It may be attached
above or below the floor. Secure the screen with the included staples.
OUTSIDE AIR EQUIPMENT
Cover plate is used
to block off room air .
Insulation is used to seal the
side edges of the pedestal .
3
Prop the front of the stove up 12" and pry out the ashpan pedestal knockout with a large screwdriver.
NOTE: If using
outside air, remove
this knock-out.
4
Follow the instructions on pages 1 through 4 of this instruction sheet for installing the ashpan
pedestal. With the pedestal in place, tuck the insulation included with the pedestal underneath the
side edges of pedestal to seal off any air from entering underneath the pedestal.
5
The cover plate seals the area around the air control rod. Remove the two screws and bridge from
the cover plate. Slide the cover plate underneath the air control rod and re-attach the bridge.
Remove the two screws that hold the
bridge to the cover plate. Then replace
the bridge when the cover plate is in
place.
Page 5 of 7
Drop Chute
Knock-Out
Phillips
Screwdriver
Screen is used to prevent
rodents from entering.
Staples are used to
attach the screen to
the floor.
FRONT OF STOVE
The cover plate has a clip which
attaches it underneath the air control.
Part # 99200125
Standard Pedestal
Outside Air Knock-Out
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
Rear Blower Knock-Outs
Bridge
Air Control
Rod
Printed September 4, 2008
Advertisement
