Advertisement
Avalon Ashpan Installation Instructions
5 b
This kit includes four bricks. Locate the 9" x 3-3/4" and 4-1/2" x 2-5/8" bricks, they are used for the
Olympic (1190). The other two bricks may be discarded. Use the bricks inside the firebox, along
with the two bricks for the Olympic (1190), to form the brick pattern shown below (NOTE: you will
have two full-size bricks remaining - these bricks may be discarded).
Standard Olympic (1190) Floor Brick Pattern
F
F
6
Follow the directions titled "Avalon Ashpan Operating Instructions" (on pages 6 & 7 of these
instructions) for installing & removing the ashpan.
Outside Air Installation
This pedestal has an internal air duct that may be used to direct air to the combustion chamber. Follow
the directions below prior to installing the stove or attaching the pedestal.
!
Outside air is required for mobile home installations and in certain localities.
+
Read the section "Outside Air Requirements" in the owner's manual prior to installing outside air.
1
Before placing the stove on pedestal, determine the location of the hole that is cut through the floor
protection and floor. The illustration on the following page details the location where this hole may
be cut in relation to the faceplate of the stove. Cut a hole at least 16 square inches in area that does
not interfere with structural members of the home.
Top View
FRONT
The faceplate of the Rainier
(990) is 3/8" in front of the
forward edge of the pedestal
base. The Olympic (1190) is
7/8" in front.
Page 4 of 7
A
B
F
B
F
C (included with ashpan pedestal)
D (included with ashpan pedestal)
26"
16"
A
D
B r i c k
A
B
F
18-3/4"
17"
Ashpan Pedestal Olympic (1190) Floor Brick Pattern
A
C
B
B
F
S i z e
8-1/4" x 4-1/2"
6-3/8" x 4-1/2"
9" x 3-3/4"
4-1/2" x 2-5/8"
Full (9" x 4-1/2")
Outside air may be drawn from this
area underneath the pedestal
(min. 16 square inches)
Pedestal Base
(without dowels)
Printed September 4, 2008
Part # 99200125
A
F
Advertisement
