Avalon Ashpan Installation Instructions
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
Avalon Rainier-90's (990) with Serial Number 4076 or Larger
Avalon Olympics (1190) with Serial Number 9760 or Larger
TOOLS REQUIRED
• Large Screwdriver
PACKING LIST
• Pedestal
• Ashpan
• Drop Chute
• Stove Gasket Cement
• Outside Air Equipment (Rodent Screen, Staples, Cover Plate, Insulation)
INSTALLATION INSTRUCTIONS
?
If using outside air, see "Outside Air Installation" on page 4 & 5 of these instructions.
1
Place the pedestal into position on the floor protection. Lift the pedestal up and insert the two
dowels included with this kit onto the forward and rear edge of the pedestal base. Lift the stove onto
the pedestal base (with the ashpan removed). Line up the press-nuts on the bottom of the stove with
the two attachment brackets on the pedestal. Insert the four bolts, with washers, through the brackets
on the pedestal and into the stove. Tighten the bolts with a 9/16" wrench.
Use a 9/16" wrench to attach the four
pedestal bolts to the bottom of the stove.
The lag bolts and washers
may be inserted through
these holes to anchor the
pedestal to the floor.
Page 1 of 7
• 9/16" Wrench
• 7/16" Wrench
• Four 3/8"x3/4" Bolts & Washers
• Two Dowels
The dowels insert onto the front and
back edge of the pedestal base.
• Four Bricks (only two are used - see the instructions below)
• Two Lag Bolts, Washers
Stove
Part # 99200125
• Drop Chute Gasket
Pedestal
(without ashpan)
Printed September 4, 2008