Cleaning And Maintaince - UFO MICATRONIC T23EN User Manual

1. If the distance of the object detected by the sensor and the control panel, is between
~1 m to ~20 cm. (This distance may vary according to the shape and color of the
objects),then it lowers the heating power to a minimum level automatically. In this
case, heater will react in a short time, when object is detected.
2.If the distance of the object detected by sensor and control panel is lower than 20
cm., after ~7 seconds, heater warns you with a 3 long "beep" signal and "Er" error
on control panel. Then it returns back to stand by mode "H0". Press On/Off button to
reactivate the heater again.
WARNING! "Safety Distance Sensor" do not work when objects are as close as to a
touching distance.
WARNING! Position of appliance shouldn't be the way across the bright white surfaces
or mirrors. Because appliance can lower it's the power level. In this case, change your
appliance's position into the right direction or call your dealer to get service.
WARNING! If you keep your hands on the control panel over 7 seconds while controlling
manually by buttons, heater reacts with warnings as described above. This is not a fault
but a secondary safety function against tipping over risk.
6. CLEANING AND MAINTAINENCE
Before cleaning or maintenance, turn off your heater and unplug the power cord.
Maintenance
Maintenance is very important for the safe use of the heater.
1- Check your heater regularly. If there is a deformation such as cracks or disjoints on
the heater body, filament glass tube, plastic cover and heater stand, do not operate your
heater and consult to an authorized technical service.
2- Check the power cord and plug carefully. If you see any deformation such as scratches,
cracks or punctures, do not plug it and consult to an authorized technical service.
Cleaning
1- Use a soft cloth with light soapy water to clean the heater. Then wipe it with a dry soft
cloth. Never let water drip into the heater.
2- If filament and/or reflector is dirty, clean with dry air externally. Never try to remove the
protective grid. If it is not possible to remove the dirt, consult to an authorized technical
service.
29