Assembly - UFO MICATRONIC T23EN User Manual

3. ASSEMBLY

• Assemble the main body and base by using
the "Base Screws". Tighten the base and body
firmly by screwing clockwise as indicated on
figure 2. Make sure that assembly is correct
and heater is well balanced on the base.
22
Figure: 1
Figure: 3
• Before attaching the right and left base, place
the power cord into the hole which is located
on the left base. Then attach two parts firmly as
shown in Fig. 1.
• Be careful not to damage power cord while
attaching the base.
Figure: 2
• Push and insert the power cord to the hole
which is located at the back of the base as
shown in figure 3.