Advertisement
Off Time Settings
Press Timer Off button.
Press/ buttons to set hour and minutes.
Press Timer Off button to save your settings.
Sleep Timer Settings
Warning! The time is to be set precisely and the heater is to be operating before using Sleep Timer function.
Press Sleep button.
Press/ buttons to set sleep time from 1 to 12 hours.
Press Sleep button to save your settings.
Remaining time will appear on the screen.
Note:
Press Cancel button to cancel all time settings. The settings will recede unless you press (Clock, Timer On, Sleep ve Timer
Off) necessary button to save your time settings in 20 seconds.
Press Cancel button to cancel all kinds of time settings.
Repeated presses on the buttons will gear the speed of buttons and intervals with the presses will slow down the process.
Press Cancel button with the intervals of 3 seconds to cancel all settings of your remote control.
Set your Sleep timer again in case of turning off and on the heater.
Once you set your On/Off time, such functions will operate in daily set times.
The heater is to be in stand-by mode to operate On timer.
Clock and UFO logo keeps functioning in Stand by mode.
6.4 Manual Operation
Control through the main module on the heater:
HO indicator appears on the screen when the heater is switched on and it is in stand by mode.
The 1st digit on the screen illustrates H symbol while 2nd digit illustrates power level mode from 1 to 5.
The button number 1 on the heater functions as ON / OFF. The heater starts operating at the power level mode at which it has
been switched off.
Press the button number 2 on the heater to adjust power mode.
H0 appears on the screen when pressed ON / OFF button and the power level mode (H1, H2, H3, H4 and H5) is adjusted
through the buttons on the remote control.
Press ON / OFF button on the remote control or the heater itself to switch off the heater.
The heater starts functioning in stand by mode after electricity cut.
LED keeps flashing in case of a program set by remote control.
Buzzer signal is given following each command.
See Fig. 12 (P. IV)
7. Cleaning and Maintenance Instructions
Maintenance
Attention! Careful and regular maintenance of UFO Infrared Heater considering our instructions assume great importance so
as to attain a long and efficient operation of your appliance.
1- Check the filthiness of the Reflector and IR – Filament at least once a month. If necessary, apply cleaning and maintenance
instructions.
2- The number of checks may be increased considering the amount of the dust in the environment.
3- Check the deformation of the Reflector, Wire and Frame visually while cleaning the appliance. In case of any deformation,
consult to your technical service.
4- Check the Power Cord and Plug visually while cleaning the appliance. In case of any deformation, consult to your technical
ENGLISH
service.
5- It is recommended to change the Reflector every 2 years for the purposes of more efficient operation of your appliance.
5
Advertisement
