We would like to thank you for your right choice and for your confidence in UFO. For an efficient and safe use, please read this manual carefully and pay attention to the safety precautions section.
Check the safety of the electric network. The fuse must be 16A. • Do not use your UFO heater together with other devices at the same electricity cable or fuse. • Use your appliance with a properly earthed plug.
Page 6
You can carry it after you wait 10-15 min. cool down of the main body. For Remote Control Model, T23EN; WARNING! This heater is not equipped with a device to control the room temperature.
IMPORTANT! Original UFO heaters can be distinguished from the counterfeit heaters with the embossed UFO logo ,serial number and markings which indicates model on the quartz glass of its filament. In case of repair, original parts should be used in order to ensure a long life time and provide an efficient operation of the heater.
3. ASSEMBLY • Before attaching the right and left base, place the power cord into the hole which is located on the left base. Then attach two parts firmly as shown in Fig. 1. • Be careful not to damage power cord while attaching the base.
4. OPERATING THE DEVICE UFO MICATRONIC heater, has 2 different model; the model with remote control (T23EN) and the model with thermostat control (T19EN). WARNING! Visible glowing of heating element can be seen ~45 seconds later, after the appliance starts to operation.
WARNING! Insert the batteries of your remote control. 4.1.2. Definition and Function of the Indicators on the Remote Control Symbol Definition Power mode indicator Time settings indicator On time indicator Off time indicator Indicates remaining time to switch off the heater Indicates that “Everyday”...
Page 11
The screen of the remote control starts functioning after inserting the batteries. UFO logo and flashing clock indicator starts appearing on the screen. Make sure that the heater is plugged in and “H” is seen on display screen which indicates the heater is functioning. “H0” indicates that the heater is in stand by position.
Page 12
If you set only the “On Time” but “Off Time” is not set, heater will operate WARNING! continuously until turned off manually. a) Timer On Settings Press Timer On button while the heater is operating. “On” icon flashes on the remote control panel.
Once you set your On/Off time, such functions will operate in daily set times. The heater is to be in stand-by mode to operate On timer. Clock and UFO logo keeps functioning in Stand by mode. 4.1.4. Manuel Operation with Control Panel When the heater is plugged, H0 appears on the control panel indicating that the heater is at stand by mode.
5. SAFETY FUNCTIONS 5.1. Tip Over Protection UFO MICATRONIC, has “Tip Over Protection” system to prevent the risk of fire in case of heater is tipped over. This function works differently in “Remote Control Model” and “Thermostat Model”.
1. If the distance of the object detected by the sensor and the control panel, is between ~1 m to ~20 cm. (This distance may vary according to the shape and color of the objects),then it lowers the heating power to a minimum level automatically. In this case, heater will react in a short time, when object is detected.
7. CLEANING AND MAINTAINENCE Attention! Only technical services and persons authorized by UFO may serve, repair and replace the spare parts ofthis heater. Points to be considered before shipping the product to the technical service: 1- Make sure that the thermostat of your appliance is in “0” mode.
Page 19
İbraz edilen Garanti Belgesinin arızalı ürüne ait olması şarttır. 6- Üzerinde satıcı firma kaşesi ve imzası ile satış tarihi belli olmayan belgeler geçersizdir. UFO tarafından verilen bu garanti, cihazın normalin dışında kullanılmasından doğacak arızaların giderilmesini kapsamadığı gibi, aşağıdaki durumlarda da garanti dışıdır.