Step 3 - Installing The Guardcam - ESP GuardCam Manual

Step 3 - Installing the GuardCam

IMPORTANT - IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT,
CONSULT A QUALIFIED ELECTRICIAN
G
This product must be grounded
G
Do not mount the unit against inflammable surfaces
G
The motion detector will not operate correctly if it is installed:
- Near the outlet of a central heating boiler
- Near air conditioning plant
- Pointing directly at moving vehicles
- Within sight of reflections from moving water
- Where other lamps could shine on the detector
BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE
ELECTRICAL SUPPLY IS SWITCHED OFF AND THE CIRCUIT FUSES REMOVED OR THE
CIRCUIT BREAKER IS IN THE OFF POSITION.
Please make sure the voltage and polarity are correct before connection. Incorrect
voltage may cause electric shock. If you are not sure, please contact your retailer.
Note: It is recommend to mount GuardCam 2M above the ground for optimum
performance, do not mount the fixture below 1.2M. See Fig. 3 for details
of performance range.
Detection range: 10M x 160° (see Fig. 3)
Fig. 3
www.cctvireland.ie Lo-Call 1890 866 900 e-sales@cctvireland.ie
5