Focal Point F500241 Installation & User's Instructions
  1. Manuals
  2. Brands
  3. Focal Point Manuals
  4. Indoor Fireplace
  5. F500241
  6. Installation & user's instructions

Focal Point F500241 Installation & User's Instructions

High efficiency gas fire
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION & USER INSTRUCTIONS
WALL MOUNTED HIGH EFFICIENCY GAS FIRE
Focal Point Fires plc.
Christchurch, Dorset BH23 2BT
Tel: 01202 499330
Fax: 01202 499326
www.focalpointfires.co.uk
e : sales@focalpointfires.co.uk
BLENHEIM HIGH EFFICIENCY
Please note : Except where otherwise stated, all rights, includ-
ing copyright in the text, images and layout of this booklet is
owned by Focal Point Fires plc. You are not permitted to copy
or adapt any of the content without the prior written permis-
sion of Focal Point Fires plc.
MODELS COVERED BY THESE INSTRUCTIONS
BLENHEIM HIGH EFFICIENCY GAS FIRE -
GAS FIRE
F500241
The products covered by this booklet are protected under
patent GB2275331B.
All instructions must be handed to the user for safe-
Revision A - 07/09
GB IE
keeping.
© 2009 Focal Point Fires plc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the F500241 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Focal Point F500241

Summary of Contents for Focal Point F500241

  • Page 1 GB2275331B. owned by Focal Point Fires plc. You are not permitted to copy All instructions must be handed to the user for safe- or adapt any of the content without the prior written permis- keeping.

  • Page 2: Table Of Contents

    [1] GB - Gas Safe registered operatives (Northern Ireland only- CORGI registered operatives) are the only class of person considered as competent by the HSE under the Gas Safety (Installation and Use) Regulations 1998. © 2009 Focal Point Fires plc.

  • Page 3: Appliance Data

    Any existing under grate draught device must be sealed off. WARNING This fire is designed to get very hot! The fireplace opening wall or back panel must be non-combustible and rated to withstand 150 © 2009 Focal Point Fires plc.

  • Page 4: Debris Collection Space

    CLAY/CEMENT LINES OR BLOCK FLUE WHICH IS NEW, UNUSED, OR PREVIOUSLY ONLY USED WITH A GAS FIRE. X Dimension = 20mm UNLINED FLUE OR CHIMNEY WHICH HAS BEEN PREVIOUSLY USED FOR A SOLID FUEL OR OIL BURNING APPLIANCE X Dimension = 60mm © 2009 Focal Point Fires plc.

  • Page 5: Ventilation

    Lengths of sealing strip Screw pack; 6 x No8 x 5/16 Self tapping type, 2 x M4x12 Machine screw type. Spigot restrictor Deflector baffle Spigot restrictor Smoke match tube Set of manufacturers instructions. Wall Plugs © 2009 Focal Point Fires plc.

  • Page 6: Preparing The Appliance

    Any sleeving should be sealed to the pipe at its ends. Inlet restrictor elbow Figure 5 The open end of the gas supply pipe should be temporarily sealed to prevent ingress of dust and dirt during installation. © 2009 Focal Point Fires plc.

  • Page 7: Cable Fixing

    If under any circumstances the electric spark fails, the pilot may be lit manually by proceeding with the ignition sequence as previously described, and after turning the control knob through the spark position, the knob should be held in and the pilot lit with a taper. © 2009 Focal Point Fires plc.

  • Page 8: Fuel Bed Layout

    Never add extra ceramics, or change them for a different type. Never throw rubbish or other matter onto the Note: Pilot viewing hole fuelbed. © 2009 Focal Point Fires plc.

  • Page 9: Final Assembly

    To decrease the setting to low, turn the control knob clockwise to the LOW setting. To turn to the PILOT position from the HIGH or LOW positions, press the control knob in, and return to the pilot posi- tion and release. © 2009 Focal Point Fires plc.

  • Page 10: Setting Pressure

    Finally, repeat with all doors open. DO NOT allow the fire to be used until the test is satisfactorily passed. © 2009 Focal Point Fires plc.

  • Page 11: Briefing The Customer

    Do not damage or try to remove the pilot injector. The unit is factory set and the only check necessary is to ensure the spark gap is correct. See section 2.0 Appliance data for gap setting. See section 9.1 for full details of the pilot assembly. © 2009 Focal Point Fires plc.

  • Page 12: Troubleshooting Guide

    • Spillage occurring. Carry out Spillage test and rectify any problems. • Combustible materials used in incorrect positions. • Firebox grommet seal missing, rectify. • Other airborne contaminants such as dust, tobacco smoke, paint vapours. © 2009 Focal Point Fires plc.

  • Page 13: Gb - Gas Safe Tm Registered Operatives (Northern Ireland Only- Corgi Registered Operatives) Are The Only Class Of Person Considered As Competent By The Hse Under The Gas Safety (Installation And Use) Regulations

    [1] GB - Gas Safe registered operatives (Northern Ireland only- CORGI registered operatives) are the only class of person considered as competent by the HSE under the Gas Safety (Installation and Use) Regulations 1998. © 2009 Focal Point Fires plc.
  • Page 14 [1] GB - Gas Safe registered operatives (Northern Ireland only- CORGI registered operatives) are the only class of person considered as competent by the HSE under the Gas Safety (Installation and Use) Regulations 1998. © 2009 Focal Point Fires plc.
  • Page 15 Contact details of Engineer As our policy is one of continuous improvement and development , we hope therefore you will understand we must retain the right to amend details and/or specifications with- out prior notice. © 2009 Focal Point Fires plc.

Table of Contents