Focal Point NOIR L23 Installation & User's Instructions
  1. Manuals
  2. Brands
  3. Focal Point Manuals
  4. Indoor Fireplace
  5. NOIR L23
  6. Installation & user's instructions

Focal Point NOIR L23 Installation & User's Instructions

Wall mounted high efficiency gas fire
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION & USER INSTRUCTIONS
WALL MOUNTED HIGH EFFICIENCY GAS FIRE
Focal Point Fires plc.
Christchurch, Dorset BH23 2BT
Tel: 01202 499330
Fax: 01202 499326
www.focalpointfires.co.uk
e : sales@focalpointfires.co.uk
Please note : Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Focal Point Fires plc. You are not per-
mitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.
MODELS COVERED BY THESE INSTRUCTIONS
L23 NOIR
NOIR
The products covered by this booklet are protected under
patent GB2275331B.
All instructions must be handed to the user for
1
-
F500184
safekeeping.
Revision A - 01/09
GB IE
©
2009 Focal Point Fires plc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NOIR L23 and is the answer not in the manual?

Questions and answers

Related Manuals for Focal Point NOIR L23

Summary of Contents for Focal Point NOIR L23

  • Page 1 GB2275331B. booklet is owned by Focal Point Fires plc. You are not per- All instructions must be handed to the user for mitted to copy or adapt any of the content without the safekeeping.

  • Page 2: Table Of Contents

    [1] Until 31 March 2009, CORGI registered (after 1 April 2009 Gas Safe registered) operatives are the only class of person considered as competent by the HSE under the Gas Safety (Installation and Use) Regulations 1998. © © 2009 Focal Point Fires plc. 2009 Focal Point Fires plc.

  • Page 3: Appliance Data

    The appliance must not be positioned ver- tically within 60mm (2.4”) of a solid floor (i.e. wood or stone) or hearth. This dimension is measured vertically to the bottom of the appliance firebox. © 2009 Focal Point Fires plc.

  • Page 4: Ventilation

    Please dispose of all the packaging materials at your local recycling centre. 5.1 COMPONENT CHECKLIST QUANTITY DESCRIPTION Firebox and burner assembly Set of manufacturers instructions Decorative glass facia assembly Screw and wall plug pack Rubber grommet Fitting template © 2009 Focal Point Fires plc.

  • Page 5: Gas Supply Routes

    Focal Point Fires plc. assumes absolutely no responsibility for injuries and/or damages that load of the appliance. Measures may occur due to improper installation or handling. The appliance should not be installed should also be taken to ensure until all wet plastering and/or dry wall sanding and wall painting has been completed.

  • Page 6: Checking The Burner & Spark Gap

    Figure 8 © 2009 Focal Point Fires plc.

  • Page 7: Fitting The Decorative Frame

    13. Check the purpose provided ventilation is un-obstructed. 14. Light the fire and test setting pressures. 15. Check safe operation of the appliance by performing a combustion test as detailed in section 10.3. For specific servicing instructions, see relevant sections. © 2009 Focal Point Fires plc.

  • Page 8: Pilot Assembly

    100% smoke tight and small quantities of smoke may be seen in corners of joints and gasket faces etc without affecting safety when the fire is in operation. © 2009 Focal Point Fires plc.

  • Page 9: Troubleshooting Guide

    • Leakage occurring. Carry out leakage test and rectify any problems. • Combustible materials used in incorrect positions. • Airborne substances such as cleaning materials/air fresheners are being drawn through the fire. • Other airborne contaminants such as dust, tobacco smoke, paint vapours. © 2009 Focal Point Fires plc.

  • Page 10: Outlet Openings : Figure

    The minimum clearance to the ceiling above the appliance is 800mm (31.5”) measured from the top of the appliance glass panel. Combustible materials should not be positioned directly in front of the appliance within a distance of one metre. © 2009 Focal Point Fires plc.
  • Page 11 Test on a hidden part before cleaning. Clean only in the direction of the grain. GLASS PANEL - This can be cleaned with a suitable glass cleaner. Test on a small area first. PAINTED AREAS - These can be cleaned using a dry cloth. © 2009 Focal Point Fires plc.
  • Page 12 [1] Until 31 March 2009, CORGI registered (after 1 April 2009 Gas Safe registered) operatives are the only class of person considered as competent by the HSE under the Gas Safety (Installation and Use) Regulations 1998. © 2009 Focal Point Fires plc.

This manual is also suitable for:

F500184

Table of Contents