Konica Minolta Bizhub Pro 1050 User Manual page 464

Utility Tool
Setting Up an AS/400 System to Use lpd
When working with the output queue description (WORKOUTQD), there are
several fields that must be defined for the network interface card to function
properly as a remote printer device.
Use the following procedure to define fields for the network interface card to
make it function as a remote printer:
1
When prompted for the remote system, type INTNETADR so the AS/
400 recognizes the device as an IP device
2
Port must be [PRINT].
3
Connection type must be [IP].
4
Internet address must be the IP address of the network interface card.
5
Destination type must be [OTHER].
6
When prompted for transforming SCS to ASCII, type YES to allow the
AS/400 do the character translation.
7
Manufacturer type and model must be the print driver that goes with
your print controller.
Setting Up a DEC ULTRIX 4.3 RISC or OSF1 Remote Printer
Use the following procedure to set up a remote printer on the host that sends
jobs to the network interface card.
1
At the prompt, type: lprsetup, then select [add].
2
Enter a name for your printer, then press [Enter].
3
"Do you want more information on specific printer types?" Press Enter.
A list of ULTRIX-supported printers is listed.
4
Type: remote, and press [Enter].
5
Enter a printer synonym (alias) and press [Enter].
6
Designate a spooler directory and press [Enter], or accept the default
spooler directory displayed and press [Enter].
7
Designate a remote system name and press [Enter].
8
Designate PRINT as the remote system printer name and press [Enter].
bizhub PRO 1050/1050e/1050P/1050eP
15
15-41