Table of Contents
Advertisement
DVA4136 Series Direct Vent Gas Fireplace
Glass Cleaning
It is necessary to periodically clean the glass. During
start-up condensation, which is normal, forms on the
inside of the glass. This condensation causes lint, dust
and other airborne particles to cling to the glass surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas fireplace glass cleaner) within the first few weeks of
operation.
Installation of Logs, Lava Rock & Ember Material
The logs are fragile and should be handled
with care. Keep the packaging material out
of the reach of children and dispose of the
material in a safe manner.
Log Installation
1. Open the log box and remove each log from its
packaging material. Set aside the ember material
and the lava rock bags.
As with all plastic bags - these are not toys
and should be kept away from children and
infants.
2. Place the rear log (M1) on the rear log
bracket. (Fig. 37) Place the holes in the
bottom of the log over the locator pins
in the bottom bracket and the front log
bracket. (Fig. 38)
22
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam glass.
Log Identification Chart
Logs
Rear Log
Front Log
Left Log
Top Center Log
Top Right Log
Top Front Log
Figure 37
Front Left
Stop Bracket
Locator Pin
�����
������� ������
�����
Part #
10010261
10010262
10010263
10010264
10010265
10010266
Rear Log Bracket
Locator Pin
Front Burner Housing Bracket
ID #
M1
M2
M3
M4
M5
M6
LG509
10010270
Advertisement
Table of Contents
