Vermont Castings DVA4136 Installation Instructions And Homeowner's Manual page 29

Program Mode
A short push of (PROG/ TIME) button will select/
operate or de-activate the PROGRAM mode. A long
push (push & hold for more than 5 seconds) of this
button will enter into the Setting of PROGRAM mode.
Following are the Factory setting for the PROGRAM
mode:
M T W T F
Segment 1(P1) ON - 7:00am
Segment 2(P2) ON - 5:00pm
S S
Segment 1(P1) ON - 9:00am
Segment 2(P2) ON - 6:00pm
Following is the set up for the Program Mode:
Push & hold button for more than 2 seconds to enter
the setting for program mode:
M T W T F &
flash. Use UP or DOWN keys to change the setting of
"P1 ON". Push SET button to enter into next setting.
M T W T F &
flash. Use UP or DOWN to change the setting of "P1
OFF". Push SET button to enter into next setting.
M T W T F &
flash. Use UP or DOWN to change the setting of "P2
ON". Use SET button to enter into next setting.
M T W T F &
flash. Use UP or DOWN to change the setting of "P2
OFF". Push SET button to enter into next setting.
S S & &
UP or DOWN keys to change the setting of "P1 ON".
Push SET button to enter into next setting.
S S & &
UP or DOWN to change the setting of "P1 OFF". Push
SET button to enter into next setting.
S S & &
UP or DOWN to change the setting of "P2 ON". Use
SET button to enter into next setting.
S S & &
UP or DOWN to change the setting of "P2 OFF". Push
OK button to enter into next setting.
NOTE: The "flashing" stated above for the PROGRAM
setting will only last for 2 Minutes. If SET (or any other
button) button is not pushed within this period, the
system will automatically complete the "PROG/TIME
setting" process and LCD will go back to its normal
readouts.
10010270
OFF 9:00am
OFF 8:00pm
OFF - 10:00am
OFF - 9:00pm
& on LCD will
& on LCD will
& on LCD will
& on LCD will
on LCD will flash. Use
on LCD will flash. Use
on LCD will flash. Use
on LCD will flash. Use
DVA4136 Series Direct Vent Gas Fireplace
IMPORTANT NOTE TO UNDERSTAND:
The control of the appliance will be under the
SET TEMPERATURE of the thermostat. If the
set temperature is at "45° F" as it comes from
the factory, the appliance will not turn ON if the
room is not below that set temperature. If the set
temperature is at "70° F" the appliance will come
on only if this temperature is the room is below
"70°F". The mode of this transmitter can be in OFF
or THERMO and the PROGRAM will still operate.
CHILD PROOF
This feature is to be activated/de-activated by pushing
PROG/TIME & UP keys at the same time for more than
5 seconds.
When this feature is activated, the "CP" will appear
in the Room Temperature Window for approximately
5 seconds. "CP" will then be displayed in the Room
Temperature Window whenever a transmitter button is
pressed and no signal will be transmitted.
NOTE: THE MANUFACTURER IS NOT
RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSEDD BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THIS EQUIPMENT.
29