Table of Contents
Advertisement
DVA4136 Series Direct Vent Gas Fireplace
5. Place the top center log (M4).
Place the two (2) holes in the
bottom of the log over the pins on
the front log. The top of the log will
rest against the rear log. (Fig. 41)
6. Place the top right log (M5). Place
the bottom rectangular sot of this
log onto the right side of the rear
log. The cross section of the log
will rest on top of the front log.
(Fig. 41)
7. Place the top front log (M6). Place
the bottom rectangular slot of this
log onto the knob of the left log.
Place the front of the log on the
grate bar. (Fig. 42)
8. Place ember material on top of
front burner. Separate the ember
material into small pieces approxi-
mately 1/2" (13 mm) diameter and
keep 1/2" (13 mm) space between
the ember pieces.
9. Place large lava rock onto the two
sides and front of the burner tray.
(Fig. 42)
CAUTION: Do not place
any lava rock material on
the burner housing assem-
bly.
Flame Characteristics
It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to Figures
43 and 44.
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
24
Figure 41
Rear Log
Figure 42
(M1)
�����
��� ��� ������ � ����� ���
�����
Lava Rock
SIT EN/EP
�����
��� ��� ����� ���
�����
Fig. 43 Correct pilot flame appearance.
Top Right Log
(M6)
Top Center Log
(M4)
Top Front Log
(M6)
Top Center Log
(M4)
Ember Material
LG513
Top Right
Log (M5)
Front Log
(M2)
LG514
FP1541
10010270
Advertisement
Table of Contents
