Weekly Schedule - D-Link DCS-6220 User Manual

DCS-660 User's Manual
Configuration > Tools > Applications (continued)

Weekly schedule

Sunday through Saturday:
All of the time except for
Event operation
Delay second(s) before
Take snapshots at second(s)
D-Link Systems, Inc.
Select the weekdays that should perform the following
operations:
Snapshots begin at: Set the time to start operations. Setting the begin time the same
as the stop time will force the operations to run continuously.
Snapshots stop at: Sets the time to stop the operations.
If you do not wish to set a schedule, this box must be checked.
the above schedule:
Sets the time delay before restarting to check the trigger condition
detecting next event:
when the current condition is triggered.
After a snapshot is taken because of a trigger, another snapshot
after event:
will be taken after the configured time in seconds.
There are 4 conditions related to the digital input and three
Trigger condition: windows for motion detection. There can be multiple selections.
Select the appropriate digital input condition according to the
characteristics of the external device. "High", "low" indicate
external voltage input for level trigger, while "rising", "falling" is
for edge triggers. There are three windows shown for the names
you defined for motion detection. "Undefined" will show instead
of the window title if motion detection is not setup yet. An active,
named motion window must be checked for motion detection to
be possible.
Check and save this option to reset the external device at the
digital output back to the original state.
Reset output:
Using the DCS-660 with an Internet Browser
58