Digitus DN-13007 Quick Installation Manual page 9

are advised to connect the MFP to PC during installation.
Add Network Printer
A. Use Add Printer Function of MFP Control Center Software
1. Start MFP Control Center, select your MFP server and click Add
Printer (Fig 6).
2. Select USB1 Port or USB2 Port in Add printer box, choose to use IP
Address or Host Name to represent MFP Server in printer port, and
select Printing with LPR (Line Printer Remote), Printing with Raw
TCP (JetDirect) or Printing with network Path(SMB) in Select the
network printing protocol box (Fig7).
If your server is running on a different LAN than your Windows PC,
you have to choose IP address in Select IP Address or Host
Name in printer port box.
SMB Protocol is compatible for Windows 98 SE/ME/2000/XP/2003.
LPR and Raw TCP protocols are compatible for Windows
2000/XP/2003.
3. Click Apply.
4. Select the desired printer driver and click Set Port to Printer.
5. Click OK.
6. If you can not find any printer driver in Printer List, please install your
printer driver first or click Add New Printer to install the printer driver.
B. Use Standard Windows Add Printer Wizard
- Windows Platform: Windows 98SE/ME/2000/XP/2003
- Network Printing Protocol: SMB
1. Open Printers and Faxes
2. Right-click the printer for which you want to change settings, and then
click Properties
3. Click the Ports tab.
4. Clear Enable bidirectional support and click Create a new port,
and then click Local Port in the Port type section.
5. In the Port Name box, type the path to the printer in the following
format: "\\ server's host name\printer name" or "\\ server's IP address
\printer name" (Please refer to server's web pages or MFP Control
Center tool to know exact path). For example: if you set server's
host name as DN-13007 and printer name (USB1 port) as psc 1300
ser, then the network path is expressed as: \\DN-13007\psc 1300 as
9