Page 1
the heart of your home Please read this booklet and keep for future reference for the safe installation and operation of your: FREESTANDING WOODBURNER FREESTANDING WOODBURNER FREESTANDING WOODBURNER FREESTANDING WOODBURNER All installations must be in accordance with these instructions. Consult with the building authority having jurisdiction to determine the need for a permit prior to commencing the installation.
Page 2
INDEX Page No: Item No: Topic: …………….. Warnings …………….. Installation Responsibilities …………….. Floor Protector Requirements …………….. Installation Clearances …………….. Assembly Instructions …………….. Fitting Seismic Restraints …………….. Flue Installation …………….. Minimum Height of Flue System Exit Published 31/05/2010 Bronte Top Outlet AG Installation...
Page 3
1. WARNINGS THIS APPLIANCE SHOULD BE MAINTAINED AND OPERATED AT ALL TIMES IN ACCORDANCE WITH THESE INSTRUCTIONS. The Bronte Top Outlet AG is tested to N.Z. Standards AS/NZS 2918:2001. If this heater is incorrectly installed a house fire may result. For your safety follow the installation instructions carefully.
2. INSTALLATION RESPONSIBILITIES WARNING: THE APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED IN ACCORDANCE WITH AS/NZ 2918:2001 AND THE APPROPRIATE REQUIREMENTS OF THE RELEVANT BUILDING CODE OR CODES. ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN APPROVED IN WRITING BY THE TESTING AUTHORITY IS CONSIDERED TO BE IN BREACH OF THE APPROVAL GRANTED FOR COMPLIANCE WITH AS/NZS 4013.
FLOOR PROTECTOR DIMENSIONS: Refer to drawings under 4.Installation Clearances. The standard front clearance from the front of the door glass can be reduced by increasing the floor protector height, as tabled below: FLOOR PROTECTOR HEIGHT 12.5 37.5 F/P DEPTH FOR PED OR D/BASE F/P DEPTH FOR LEG BASE 4.
12. Secure the wood-burner to the floor protector for seismic restraint (refer instructions page 7). DUE TO NZ BEING AN EARTHQUAKE PRONE COUNTRY, IT IS IMPORTANT TO ANCHOR THE FIRENZO FIRE DOWN IN CASE OF EARTH MOVEMENT. 13. Assemble and fit the decorative rails.
FITTING SEISMIC RESTRAINT BRACKETS ON BRONTE TOP OUTLET AG PEDESTAL OR DRAWER BASE MODELS 1. Remove bolts at rear of fire box 2. Fit Seismic Restraint brackets 3. Secure both the floor protector and the appliance to the floor. LEG MODELS 1.
6. FLUE INSTALLATION 1. Position heater on floor protector ensuring all heater clearances are correct as per clearances on page 5. 2. Once the location is confirmed, the appliance and floor protector shall be fixed to the floor itself (refer to page 6 &...
Need help?
Do you have a question about the Lady Kitchener and is the answer not in the manual?
Questions and answers
How to replace fire bricks after cleaning
i need to replace internal refractory at the top of firebox,also correct placement of those.lower door wick also,thank you.