Table of Contents
Advertisement
Quick Links
the heart of your home
Please read this booklet and keep for future reference for the safe installation
of your:
BRONTE
FREESTANDING WOODBURNER
REAR OUTLET RU
MODEL:
THIS FIRE CAN ONLY BE INSTALLED ON A PROPERTY OF
2 HECTARES OR MORE.
All installations must be in accordance with these instructions. Consult with
the building authority having jurisdiction to determine the need for a permit
prior to commencing the installation. Failure to follow these instructions may
also void your fire insurance and warranty.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Firenzo REAR OUTLET RU
Summary of Contents for Firenzo REAR OUTLET RU
- Page 1 Please read this booklet and keep for future reference for the safe installation of your: BRONTE FREESTANDING WOODBURNER REAR OUTLET RU MODEL: THIS FIRE CAN ONLY BE INSTALLED ON A PROPERTY OF 2 HECTARES OR MORE. All installations must be in accordance with these instructions. Consult with the building authority having jurisdiction to determine the need for a permit prior to commencing the installation.
- Page 2 INDEX Page No: Item No: Topic Warnings Installation Responsibilities Floor Protector Requirements Installation Clearances Assembly Instructions Wetback Flue Installation R/O Flue Stand (optional) Edited 14/3/2011 Bronte Rear Outlet RU...
- Page 3 THIS APPLIANCE SHOULD BE MAINTAINED AND OPERATED AT ALL TIMES IN ACCORDANCE WITH THESE INSTRUCTIONS. The Bronte Rear Outlet RU conforms with N.Z. Standards AS/NZS 2918:2001. If this heater is incorrectly installed a house fire may result. For your safety follow the installation instructions carefully.
-
Page 4: Installation Responsibilities
Damage caused to the Wetback coil if fitted in a hard/corrosive water area will not be covered under the manufacturer’s warranty. Please leave this manual with the owner when installation is complete. Bronte Rear Outlet RU... -
Page 5: Floor Protector Requirements
Floor Protector Height Measurement from Door Glass 470 450 4. INSTALLATION CLEARANCES When installing the Bronte RU Rear-Outlet on a leg base ADD 70mm to vertical measurements shown: Bronte Rear Outlet RU... - Page 6 Diagram shown is for installation into an existing chimney cavity INSTALLATION WITH EXPOSED FLUE: Flue shield MUST be fitted. BRONTE REAR OUTLET 360* 1295 1400 1210 PEDESTAL BASE LEG BASE 360* 1230 1335 1165 *To combustible surface Bronte Rear Outlet RU...
-
Page 7: Assembly Instructions
10. Fit door knob. 11. Fit the control knob - place the flat on the knob to the flat on the air control shaft situated on the right hand side of the fire. Press home firmly. Bronte Rear Outlet RU... - Page 8 6. WETBACK The Bronte Rear Outlet RU can be fitted with a wetback to supplement the hot water system. WARNING: DO NOT CONNECT TO AN UNVENTED HOT WATER SYSTEM. DO NOT USE THIS FIRE WITHOUT WATER RUNNING THROUGH THE WETBACK.
-
Page 9: Installation Instructions
Locate and drill two holes for fixing depth adjustment bolts. 5. Set depth adjustment at correct measurement and lock. Fasten Promena board to bolts and tighten. 6. Slide fire into position and fix for seismic restraint. Bronte Rear Outlet RU... - Page 10 6. Slide flashing cone over top of flue, until it rests firmly over top spacer. Secure with pop rivets or self tapping screws. 7. Fit anti-down draught cowl. Do NOT secure as it must be removed for cleaning. Bronte Rear Outlet RU...
- Page 11 Bronte Rear Outlet RU...
- Page 12 HEWITSONS LIMITED Manufacturers of: Lady Kitchener Contessa Bronte Dante Viking Royale Zealandia Coaster Aqualux Athena Forte Plaza Deco 68 Austin Street PO Box 3231 Onekawa Napier Phone: 06 8438260 Fax: 06 8430505 Website: www.firenzo.co.nz Email: hothouse@firenzo.co.nz Bronte Rear Outlet RU...
Need help?
Do you have a question about the REAR OUTLET RU and is the answer not in the manual?
Questions and answers