Introduction; Rules - Atag A200SOV Instructions For Use And Installation

1

Introduction

2

Rules

4
These instructions describe the functioning, installation, use and primary maintenance of
ATAG central heating boilers for the United Kingdom and Ireland. Where necessary the
different regulations for each country are separately described.
These instructions are intended for the use by Gas Safe Register approved contractors
or registered Bord Gais installers in connection with the installation and putting into
operation of ATAG boilers. It is advisable to read these instructions thoroughly, well in
advance of installation. Separate instructions for use are supplied with the boiler for users
of ATAG central heating boilers. ATAG is not liable for the consequences of mistakes
or shortcomings which have found their way into the installation instructions or user's
manual. Further, ATAG reserves the right to alter its products without prior notification.
When delivering the boiler, give the customer clear instructions concerning its
use; present the customer with the user's manual and card.
Each boiler is fitted with an identification plate. Consult the details on this plate to verify
whether the boiler is compliant with its intended location, e.g.: gas type, power source
and exhaust classification.
On completion of the installation the installer or commissioning engineer must fill out
and complete the Benchmark Commissioning Checklist found on page 33 of this manual
and hand this to the customer for future record keeping. The Benchmark Service Record
must also be completed by the service agent following each service call, and return to
the customer. A copy of the Benchmark Commissioning Checklist must be returned to
ATAG Heating along with the warranty registration card to register the appliance for the
standard warranty benefits.
Relevant Installation, Service and User manuals:
- ATAG Monopass
The following regulations apply to installation of ATAG central heating boilers:
Legislation and Regulations.
Gas Safety (Installation and Use). All gas appliances must by law, be installed by a competent
person, eg. Members of Gas Safe Register and in accordance with the current Gas Safety
Regulation. Failure to install appliance correctly could lead to prosecution.
All Gas Safe Register approved contractors carry a Gas Safe Register ID Card and have
a registration number. You can call Gas Safe Register direct on 01256 372300
In addition to the above regulations this appliance must be installed in compliance with the
current IEE Regulations, the Building Standards (Scotland Consolidation) Regulations.
Regulations and bye laws of the Local Water Authority and the Current Health and Safety
Regulation.
The Benchmark Scheme
Benchmark places responsibilities on both manufacturers and installers. The purpose
is to ensure that customers are provided with the correct equipment for their needs,
that it is installed, commissioned and serviced in accordance with the manufacturer's
instructions by competent persons and that it meets the requirements of the appropriate
Building Regulations. The Benchmark Checklist can be used to demonstrate compliance
with Building Regulations and should be provided to the customer for future reference.
Flue system guide