Table of Contents
Advertisement
Parameter-chapter
PARA
Factory
518
5
Gradient speed CH
520
5
Do not change
532
24
Do not change
541
max.
Maximum power CH in %
Can only be reduced. 0 = low load
555
Do not change
651*
1
Do not change
652*
0
Quick selection CH installation:
CH Tmax: 85°C; Gradient: 5; Heating line 24
CH Tmax: 70°C; Gradient: 5; Heating line 19
CH Tmax: 60°C; Gradient: 4; Heating line 15
CH Tmax: 50°C; Gradient: 3; Heating line 11
This parameter copies the choosen value over CH Tmax., P518 en P532.
It is a quick selection, where the separate values will be independantly adjustable.
After selection this parameter will always show 0.
680
0
Service-parameter. Do not change
681
off
Green button function
Dependant of the level the factory settings at selection b7 and OK will be set back,
P651 excluded.
682
Dynamic functions:
off
b0: Do not change
b1 until b6: no function
off
b7: confirmation Service-parameter
683
0%
Correction factor fan speed for HP-system
See table at flue lenghtes. The adjusted value will increase the fan range with that
percentage. Write down this value on the sticker on the boiler.
684
Do not change
* Note
When an adjustment is made and it is confirmed with OK the boiler will restart and
the de-aerationprogramm will start.
Parameter-chapter
10.4 Activating the factory setting (green key function)
To re-activate the factory settings, proceed as follows (this will undo all changed settings):
-
Select P6 81, according to the procedure described in chapter 10.4;
-
Select b7;
-
Press OK. The screen is showing 'off';
-
Select 'on';
-
Press OK.
The screen then shows P6 81 and the factory settings are active again.
Description
Range
0 - 15
0 - 10 K
10 - 40
0 - max
1 - 3
1
2
3
4
0 - 10
on - off
on - off
on - off
0 - 20%
Table 6
25
Advertisement
Table of Contents
