Care And Maintenance; Cleaning The Model 7500 - Nonin 7500 Operator's Manual

Care and Maintenance

The advanced digital circuitry within the pulse oximeter of the Model 7500
requires no calibration or periodic maintenance other than battery
replacement by qualified technical professionals.
Field repair of the Model 7500 circuitry is not possible. Do not attempt to
open the Model 7500 case or repair the electronics. Opening the case
may damage the Model 7500 and void the warranty. If the Model 7500 is
not functioning properly, see "Troubleshooting."
CAUTION: Follow local, state and national governing ordinances and
recycling instructions regarding disposal or recycling of the device and
!
device components, including batteries. Use only NONIN-approved
battery packs. Batteries might leak or explode if used or disposed of
improperly.

Cleaning the Model 7500

Clean the Model 7500 with a soft cloth dampened with isopropyl alcohol,
mild detergent, or a 10% bleach (5.25% sodium hypochlorite) with water
solution. Do not pour or spray any liquids onto the Model 7500, and do not
allow any liquid to enter any openings in the device. Allow the unit to dry
thoroughly before reusing it.
.
WARNING:
Do not use this device in or around water or any other liquid,
with or without AC power.
CAUTION:
!
abrasive cleaning agents on the device. Do not gas sterilize or autoclave
this device. Do not place liquids on top of this device.
Clean the Model 7500 separately from its associated sensors. For
instructions regarding cleaning pulse oximeter sensors, refer to the
appropriate pulse oximeter sensor package inserts.
18
Do not immerse this device in liquid, and do not use caustic or
Care and Maintenance