Electrical Requirement - Haier AU282AHBEA Service Manual

Fig. 15
Wire
HOW TO FIX CONNECTION CORD AND POWER CABLE AT THE CORD CLAMP
After passing the connection cord and power cable through the insulation tube, fasten it with the cord
clamp, as shown in Fig.16

ELECTRICAL REQUIREMENT

Electric wire size and fuse capacity:
Fig. 16
(1) Match the terminal block numbers and connection cord colors with those of the
outdoor unit. Erroneous wiring may cause burning of the electric parts.
(2) Connect the connection cords firmly to the terminal block. Imperfect installation
may cause a fire.
(3) Always fasten the outside covering of the connection cord with the cord clamp.
(If the insulator is chafed, electric leakage may occur.)
(4) Always connect the ground wire.
A. Solid wire
Loop
Insulation
Screw with
special washer
Round
terminal
Terminal
block
Series
Connection
cord
(mm )
2
Fuse capacity(A)
Insulation tube
Use VW-1, 0.5 to 1.0 mm thick, PVC tube as the insulation tube.
>a__WcU[S^ <[c >a`V[e[a`Wc
B. Strand wire
Wire
Table 5
28,36,42,52
MAX 3.5
2.0
MIN
30
Cord clamp
CAUTION
-143-
Round terminal
Screw with
special washer
Round
terminal