Electrical Requirement; Electrical Wiring - Haier AC092ACBHA Operation And Installation Manual

Installation Procedures

ELECTRICAL REQUIREMENT

Electric wire size and fuse capacity:
Table 5
MAX
Connection
cord
MIN
(mm 2 )
Fuse capacity(A)

ELECTRICAL WIRING

CAUTION
(1) Match the terminal block numbers and connection
cord colors with those of the outdoor unit.
Erroneous wiring may cause burning of the electric
parts.
(2) Connect the connection cords firmly to the terminal
block. Imperfect installation may cause a fire.
(3) Always fasten the outside covering of the connection
cord with the cord clamp.(If the insulator is chafed,
electric leakage may occur.)
(4) Always connect the ground wire.
1. INDOOR UNIT SIDE
(1) Remove the electric component box.
Fig. 26
Fig. 27
Electric component box
Remove the four tapping
screws.
CAUTION
Do not remove the screws. If the screws
are removed, the electric component
box will fall.
3.5 3.5
2.5 2.5
20 30
Electric component box
21
(2) Pull out the electric component box.
Fig.28
(3) Remove the electric component box cover.
Fig. 29
Base
Remove the three tapping screws.
CAUTION
Be careful not to pinch the lead wires
between the electric component box
and base.
(4) Wiring
(1) Remove the cord clamp.
(2) Process the end of the connection cords to the
dimensions shown in Fig.34.
(3) Connect the end of the connection cord fully into the
terminal block.
(4) Fasten the connection cord with a cord clamp.
(5) Fasten the end of the connection cord with the
screw.
Fig. 30
to power supply
Electric component box
Electric component box cover
Indoor unit
1 2 3
termianl block
Outdoor unit
1(N) 2(L) 3(C)
termianl block