Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
IMPORTANT –
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Approximately 1 hour
• We recommend that two people install
this product.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
ELECTRICAL REQUIREMENTS
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall
outlet you plan to use is only a 2-prong outlet,
it is your responsibility to have it replaced with
a properly grounded 3-prong wall outlet.
These models require 230/208-volt AC,
protected with a time-delay fuse or circuit breaker.
These models should be installed on their own single
branch circuit for best performance and to prevent
overloading house or apartment wiring circuits, which
could cause a possible fire hazard from overheating
wires.
8
Save these instructions
Observe all governing
ELECTRICAL REQUIREMENTS (CONT)
CAUTION
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case.
The device should be tested on a periodic basis by first
pressing the TEST
while plugged into the outlet. If the TEST
not trip or if the RESET
discontinue use of the air conditioner and contact a
qualified service technician.
TOOLS YOU WILL NEED
Phillips head screwdriver
Drill and 1/8" drill bit
Pencil
Level
RESET
Ruler or tape measure
Scissors or knife
49-5000567 Rev. 0
Advertisement
Chapters
Table of Contents
