The Remote Control - Broseley Winchester Installation And Operation Manual

Page 13 of 20

THE REMOTE CONTROL

POSITIONING THE RECEIVER
After fitting the batteries in the receiver and the hand set, place the receiver anywhere on the
hearth. There is a long lead on the receiver to allow you to position the receiver towards the front
of the hearth, if you wish to see the light come on when the handset is in use. Place the lead on
the hearth also. Failure to do this will cause malfunction of the unit.
OPERATING INSTRUCTIONS FOR G30-ZRPTT REMATE CONTROL
Caution! Read these instructions entirely before use.
G30-ZRPTT remote controls must be installed and operated according to all locally applicable
regulations!
G30-ZRPTT Remote Controls are designed for use only in gas fires equipped with specially
designed combination controls (GV34 or GV36 retrofitted with a motor) produced by Mertik
Maxitrol. Due to the integrated thermostat, the G30-ZRPTT is not to be used with open gas
fires!
Technical Data
Ultrasound Transmission
Ambient Temperature
Batteries
Connections
The G30-ZRPTT is intended for use only with motorized gas
combination controls models GV34 (or GV36 retrofitted with a
motor). The receiver cable must be firmly plugged onto the flat blade
connectors (motor: 6.3 and 4.8mm micro switch both 2,8mm see
illustration 2).
Range: 1...10m
Frequency: ON 40,5kHz,
Transmitter & Receiver
Connecting Cables:
Handset: 1 x 9V block (alkaline recommended)
Receiver: 4 x 1,5V AA (alkaline recommended)
3...33ft.
OFF 40kHz
max. 60°C 140°F
max. 180°C 356°F
A
B