Subscribe to Our Youtube Channel
Related Manuals for Broseley GB09b
Summary of Contents for Broseley GB09b
- Page 1 Installation and Operation Manual Winchester Gas Stove Revision: GB09b © 2007-2008 Broseley Fires Ltd...
- Page 2 Servicing Instructions Sitting the appliance Spillage monitoring system Stove assembly Test for Spillage Troubleshooting Ventilation Broseley Fires Ltd Knights Way Battlefield Enterprise Park Shrewsbury SY1 3AB United Kingdom Telephone +44(0) 1743 461444 Fax +44(0) 1743 461446 © 2007-2008 Broseley Fires Ltd...
- Page 3 Height 595mm Height to centre of rear flue spigot 455mm Depth 465mm Width 590mm Centre of top flue to rear of stove 150mm Flue spigot diameter 127mm Weight 116kg Maximum heat output (approx.) 5.6 Kilowatts © 2007-2008 Broseley Fires Ltd...
- Page 4 THANK YOU FOR PURCHASING A GAS FIRED STOVE Broseley Fires Ltd, a family run company, was founded as an appliance and design development company in 1975. Since then we have built up an enviable reputation for the quality, reliability and fuel efficiency of our stoves.
- Page 5 2 x burner fixing brackets and screws 2 x burner retaining bolts with nuts 1 x remote control unit with plug-in sensor unit Ceramic Box Coal Option – See page 9 Log Option – See page 10/11. © 2007-2008 Broseley Fires Ltd...
- Page 6 This problem can normally be overcome by fitting an approved gas cowl. It is essential for the effective running of your stove that the chimney draws properly to allow the products of combustion to escape. © 2007-2008 Broseley Fires Ltd...
-
Page 7: Ventilation (Gb Only)
Replacement ceramics are available from your dealer. Whilst arranging the ceramics, ensure that the pilot is not obstructed. Broseley Fires Ltd accepts no responsibility for any injury sustained whilst handling hot ceramics. Before any ceramics are placed in position ensure that the burner is operating correctly. - Page 8 Do not push them into the gap, as this will prevent the flames from burning evenly and effectively. The path of the flame should not be obstructed. IMPORTANT Please follow these instructions carefully. Ceramics that are positioned wrongly could seriously alter the performance of your appliance. © 2007-2008 Broseley Fires Ltd...
- Page 9 Winchester Coal Fitting Instructions Stage 1 Stage 2 Stage 3 Stage 4 © 2007-2008 Broseley Fires Ltd...
- Page 10 This log is located on a lug that has been formed on top of the rear log. Please make sure that this log and all others are in position, exactly as shown in the diagrams. © 2007-2008 Broseley Fires Ltd...
-
Page 11: Operating The Stove
Contact your dealer for a replacement to be fitted before relighting the appliance. PLEASE EXPLAIN TO THE CUSTOMER THESE LIGHTING AND EXTINGUSIHING PROCEDURES AND THAT IT IS NORMAL FOR THE STOVE TO GIVE OFF ODOURS WHILST THE PAINT, SEALANT AND CAST IRON MATURES. © 2007-2008 Broseley Fires Ltd... -
Page 12: The Remote Control
The G30-ZRPTT is intended for use only with motorized gas combination controls models GV34 (or GV36 retrofitted with a motor). The receiver cable must be firmly plugged onto the flat blade connectors (motor: 6,3 and 4,8mm; micro switch: both 2,8mm, see llustration 2). © 2007-2008 Broseley Fires Ltd... - Page 13 • The “send“ symbol appears in the upper left corner of the display when either button is depressed. • The LED of the receiver flashes when knob B of the valve reaches its end stops. Automatic Mode (AUTO in display) for Temperature Control © 2007-2008 Broseley Fires Ltd...
- Page 14 NOTE TO THE INSTALLATION ENGINEER Please make sure the customer is familiar with the initial lighting and operating procedures before leaving the site and that this instruction booklet is left with them when the final commissioning is complete. © 2007-2008 Broseley Fires Ltd...
-
Page 15: Test For Spillage
4. Should the appliance turn itself off, wait for a minimum of 3 minutes before attempting to re-light. In the event of your stove tripping out, consult your installation engineer to have the flue / chimney checked. © 2007-2008 Broseley Fires Ltd... -
Page 16: Troubleshooting
Ideally a vacuum cleaner should be used, but a soft brush will do. • Check the condition of the coals. Any damaged ones will affect the efficient operation of the stove and should be replaced with new ones available from your stove supplier. © 2007-2008 Broseley Fires Ltd... -
Page 17: Curing The Paint
Please retain your purchase receipt. We will need to see this in the event of a claim under warranty. © 2007-2008 Broseley Fires Ltd... - Page 18 Is the aeration of the pilot correct? Is the FFD phial in the correct position in the pilot flame? Does the flame encircle the FFD? Installation Engineers Name Address Telephone Mobile Corgi registered? Number Signed Date © 2007-2008 Broseley Fires Ltd...
- Page 19 Please retain your purchase receipt. We will need to see this in the event of a claim under warranty. Broseley Fires Ltd Knights Way Battlefield Enterprise Park Shrewsbury SY1 3AB Telephone + 44 (0) 1743 461 444 Fax + 44 (0) 1743 461 446 © 2007-2008 Broseley Fires Ltd...
Need help?
Do you have a question about the GB09b and is the answer not in the manual?
Questions and answers