Radiator Main Fan And Fan Motor - Subaru LEGACY 2004 Service Manual

8. Radiator Main Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect the connector (A) of main fan motor.
(A)
6) Remove the heat shield cover. (Model without
ATF warmer)
7) Remove the ATF hose from the clip of radiator
main fan motor assembly. (Model without ATF
warmer)
8) Lower the vehicle.
9) Disconnect the over flow hose.
10) Remove the reservoir tank. <Ref. to CO(H4SO
2.0)-29, REMOVAL, Reservoir Tank.>

Radiator Main Fan and Fan Motor

IN-00203
CO-00274
CO-00273
CO(H4SO 2.0)-25
11) Remove the bolts which hold the radiator main
fan shroud to radiator.
12) Remove the radiator main fan motor assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
When the radiator main fan motor assembly cannot
be installed, loosen the bolts which secure radiator
sub fan motor assembly.
Tightening torque:
⋅
7.5 N m (0.76 kgf-m, 5.5 ft-lb)
C: DISASSEMBLY
1) Remove the clip which holds motor connector
onto the shroud.
2) Remove the nut which holds the fan onto fan
motor and shroud.
COOLING
CO-00096
CO-00096
CO-00102