Table of Contents
Advertisement
36) POWER Switch
The Power LED will illuminate when you push this switch.
37) PHANTOM POWER Switch
The Power LED will illuminate when you push this switch. Pressing this switch applies
48V DC to all microphone input channel connectors, for remote powering of
condenser microphones.
38) HEADPHONES / CONTROL ROOM Level
This is a single volume control, which controls the level to the headphones and main
monitors.
39) HEADPHONE Function Select Switch (PFL / L-R / G1-2)
With this switch you can determine, which signal you wish to listen on the headphone.
You can select PFL, L-R or G1-2.
40) AUX SEND 1 / 2
This is used for adjusting the volume of AUX sound, when sending an AUX signal to a
jack.
41) TAPE LEVEL
You can adjust the volume of TAPE in signal when connecting TAPE in.
42) OUTPUT G1-2 FADERS
With this fader you can adjust the G1-2 output level.
11
Advertisement
Table of Contents
