Suzuki DF9,9 Service Manual page 160

6-40 POWER UNIT
6. Apply engine oil to crank journal, crank pin and conrod.
7. Install crankshaft in cylinder.
NOTE:
When installing crankshaft to cylinder, be sure to fit oil seal tabs
in grooves of cylinder.
8. Apply engine oil to conrod cap.
9. Install dowel pins 1 and conrod cap 2 to conrod.

Reassemble each conrod cap to its original position.
10. Apply engine oil to conrod cap bolts.
11. Tighten bolts to specified torque.
 Conrod cap bolt: 12 N·m (1.2 kg-m, 8.5 lb-ft)
CRANKCASE TO CYLINDER
1. Clean mating surface of cylinder and crankcase.
2. Apply the bond to mating surface of crankcase as shown.
 99000-31140: SUZUKI BOND "1207B"

Apply bond to mating surface only. Do not allow bond
to contact surface of bearing.
A – Fitting surface of the oil seal (Apply the bond.)
B – Groove for the oil seal tab (Do not apply the bond.)
C – Mating surface of the crankcase (Apply the bond.)
– marked area
– marked area
– marked area