Low Battery Alarm; Vibrator; Good Read Vibrator; Good Read Vibrator Duration - CipherLab 1664 User Manual

1664 Barcode Scanner

1.4.3 LOW BATTERY ALARM

By default, the built-in battery alarm will sound when the battery charge gets low. In
order to prevent data loss, it is advised to replace the battery immediately when hearing
two short beeps (high tone).

1.5 VIBRATOR

1.5.1 GOOD READ VIBRATOR

1.5.2 GOOD READ VIBRATOR DURATION

By default, the Good Read Vibrator stays on for 1 second. Specify a value, ranging from
1 to 254 in units of 100 milliseconds.
1) Read the barcode above to specify the time interval, in tenths of seconds before the
Good Read Vibrator goes off.
2) Read the "Decimal
vibrator to vibrate after 1.5 seconds good read.
3) Read the "Validate" barcode on the same page to complete this setting.
34
User Guide
Value" barcode on page 251. For example, read "1" and "5" for the
Disable
*Enable
Enable
Good Read Vibrator
*Disable
Good Read Vibrator
Good Read Vibrator
Time-out after
0.1~25.4 sec.
(*1 s)
Enter Setup