Direct Usb Virtual Com; Activate Usb Virtual Com; Inter-Function Delay - CipherLab 1664 User Manual

1664 Barcode Scanner

2.7 DIRECT USB VIRTUAL COM

1664 supports "Direct" USB Virtual COM interface for memory mode. Use the provided
USB cable to connect 1664 to the USB port of PC. You may run HyperTerminal.exe on a
computer to view and capture the scanned data being transmitted to the computer. Refer
to 1.2.2 Memory Mode.
Note: If using USB Virtual COM for the first time, install its driver from the CD-ROM.
Driver version 5.3 or later is required. Please remove older versions before
installing new ones!

2.7.1 ACTIVATE USB VIRTUAL COM

2.7.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of milliseconds, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
milliseconds).
3) Read the "Validate" barcode on the same page to complete this setting.
94
User Guide
Value" barcode on page 251 for the desired inter-function delay (in
*Activate Direct USB
Virtual COM
Inter-Function
Delay... (*0~254)
Enter Setup