Haier proline IDW12P-E Servise Manual page 16

Service Manual
Model No:IDW12P-E/IDW12P-U
A
Fastening the Bracket to the Wooden Panel (Fig.5 - totally built-in )- (Fig.6 integrated with
control panel)
At the point marked, drill holes 2 mm in diameter . If the panel is made of chip board , only drill
through the veneer. If the panel is made of solid wood, the holes can be made deeper. Position
the two brackets so that they are lined up with the holes made in the bottom part of the panel. The
holes furthest to the outside should be used to fasten the brackets. The small fins should be
turned downward. The hooks in the totally built-in version should be screwed into the two holes at
the top.
Mounting the Wood Door Panel onto the Dishwasher
Place the wood panel onto the door of the dishwasher.
Then perform the installation steps described below, based on whether the panel is for a totally
built-in model or integrated with the control panel.
Panel Integrated with the Control Panel
Insert the metal fins into the slots located on the dishwasher door, hooking the panel into place by
sliding it to the right (see Fig.7).
B
mm
115
122.5
130
137.5
145
152.5
582mm
586mm
590mm
594mm
LARGH.=598mm
LARGH.=598mm
594mm
590mm
586mm
582mm
Fig.3
Fig.5
B
A
Fig.4
Fig.6
15
Issue
Rev.