Table of Contents
Advertisement
Service Manual
Model No:IDW12P-E/IDW12P-U
4-5.Drain hose connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink,
making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a
connecting piece for the drain hose (fig.C). The free end of the hose must be at a height between
40 and 100 cm and must not be immersed in water.
Attention:
The connecting piece for syphon trap (U-bend) must be solidly fastened to the wall to
prevent the drain hose from moving and allowing water to spill outside the drain.
4-6.Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the stainless steel inner door of the appliance) and that the
electrical system is correct for the maximum voltage on the rating plate, insert the plug into an
electrical socket which is earthed properly (the earthing of the appliance is a safety requirement
mandated by law).If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the whole cable, rather than using adaptors as they could cause
overheating and risk of fire.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a built-in
unit so that maintenance can be done safely.
fig.C
8
Issue
Rev.
Hide quick links:
Advertisement
Table of Contents
